Long weekend project…. Got a pair of these LED fog lights for my bike and a handlebar on-off light switch. Was figuring out where to put the light switch as my handlebar has no more space… So ended up installing the switch on the engine crash bar instead – just beside the LED fog light.
For those who may be technically interested, the LED fog has 3 modes – high, low, and flashing. Draws 850mA on high, about 250mA on low, and approximately 480mA on flashing mode. So my 5A fuse provision for this is definitely way more than enough.
Continue reading “LED Fog lights install on my Pulsar 200NS”
Since I head in to our friendly northern neighbour’s occasionally, I thought it’ll be good to install a bike alarm. While it won’t defend against a truly determined thief, it helps repel the lesser skilled ones. Being the cheapo that I am, got the most basic system for about the cost of 2 Big Mac meals. No immobilizer, no blinking lights, no two-way system, no GPS tracking, no frills, no nothing. Merely screams at 110dB when the bike is moved, or is turned on when the alarm is armed. Super easy to install too – just 3 wires. 12v, ground, and a wire to detect if the bike is turned on (optional – can cut away if not used). Comes with a remote controller too.
Had previously installed my bikecam and USB power port at a bike shop. What the mechanic did was to hard wire the bikecam and USB outlet to a “Ignition ON” wire on the bike. No fuse. When I asked him what if one of these cheapo made-in-China stuff short circuits? He told me that the main fuse will blow lor.
I never liked the idea of blowing the vehicle’s fuse with these “add-on” stuff. Because, the quality of these stuff are sometimes questionable, and blowing the fuse will leave you stranded.
I’d much rather have a separate circuit with its own fuse to support these aftermarket electronic add ons. So, I headed to the drawing board and came up with this…
Edit: Subsequently repalced the 30A fuse with a 10A, and the 20A fuse with a 5A one instead.
Reducing Vibration Issues on 200NS – single cylinder engines are notorious for the vibrations when riding. Bajaj quality panels don’t help much either. I bought my 200NS pre-owned and it must have gone through several mechanics’ hands. More often than not, these mechanics merely focus on getting their job done as quickly as possible, and tend to miss out the little details – such as a bolt here, a nut there, a grommet here, or a slightly cracked plastic panel. Let’s face it, there’s nobody who has as much interest in the bike than the owner him/herself.
So, in my quest to learn more of my newly acquired machine, I had taken it apart several times. It was not until recently that I got interested in trying to reduce the vibration Continue reading “Reducing Vibration Issues on 200NS”
Just changed my headlight bulb to the new Philips X-treme Vision 130% bulb and noticed an immediate improvement in light throw compared to stock bulb. It was a direct replacement of the stock bulb. No modifications required and LTA-friendly. Now night time swee swee bright bright! Inexpensive DIY project…